TL V6-3.2L (2004)
11. Drill a 3 mm (0.12 inch) diameter hole about 2.5 - 3.0 mm (0.10 - 0.12 inch) in depth in the staked point (A) on the cylinder. Do not allow metal
shavings to enter the cylinder housing. After removing the cylinder end (B), remove any burrs at the staked point.
12. Hold the gearbox housing using a C-clamp (commercially available) (A) and the wooden blocks (B) as shown. Do not clamp the cylinder part of
the gearbox housing in the vise. Then remove the cylinder end (C).
13. Install a commercially available bearing separator (A) in the gearbox housing as shown.
14. Place an appropriate size deep socket wrench (B) on the steering rack (C).
15. Set the steering gearbox in a press so the gearbox housing side points upward, then press the cylinder end seal (D) and steering rack out of the
gearbox. Hold the steering rack to keep it from failing when pressed clear. Be careful not to damage the inner surface of the cylinder housing with
the tool.