TL V6-3.2L (2004)
27. Press the valve oil seal (A) and roller bearing (B) out of the valve housing using a hydraulic press and special tool.
28. Clean the disassembled parts with solvent, and dry them with compressed air. Do not dip rubber parts in the solvent.
Reassembly
29. Apply vinyl tape (A) to the stepped portion of the pinion shaft, and coat the surface of the vinyl tape with power steering fluid.
30. Install the wave washer (B).
31. Coat the inside surface of the new valve oil seal (C) with power steering fluid, and install the seal with its grooved side facing opposite the bearing,
then slide it over the pinion shaft, being careful not to damage its sealing lip (D).
32. Apply vinyl tape (A) to the splines and stepped portion of the shaft, and coat the surface of the vinyl tape with power steering fluid.
33. Fit the new O-ring (B) in the groove of the pinion shaft. Then slide the new valve seal ring (C) over the shaft and in the groove on the pinion shaft.
