TL V6-3.2L (2004)
10. Remove the hub bearing unit (A).
11. Install the hub bearing unit in the reverse order of removal, and note these items:
^
Tighten all mounting hardware to the specified torque values.
^
Use a new spindle nut on reassembly.
^
Wash the spindle thoroughly in high flash point solvent before reassembly.
^
Before installing the spindle nut, apply a small amount of engine oil to the seating surface of the nut. After tightening, use a drift to stake the
spindle nut shoulder against the driveshaft.
^
Before installing the brake disc/drum, clean the mating surfaces of the hub bearing unit and brake disc/drum.
^
Before installing the wheel, clean the mating surfaces of the brake disc/drum and the inside of the wheel.
^
Check the wheel alignment, and adjust if necessary.
Knuckle Replacement
1. Remove the hub bearing unit.
2. Remove the wheel sensor (A) from the knuckle. Do not disconnect the wheel sensor connector.
3. Remove the lock pin (A) from the upper arm ball joint, then loosen the nut (B).
NOTE: During installation, install the new lock pin as shown after tightening the nut.
4. Disconnect the upper arm ball joint from the knuckle using the special tool.
