TL V6-3.2L (2004)
2. Install the damper assembly on a commercially available strut spring compressor (A), and compress the spring lightly.
3. Align the bottom of the spring and the stepped part (B) of the lower spring seat.
4. Position the damper mounting base (A) so the stud bolt (B) is aligned with the aligning tab (C) in the damper unit.
5. Compress the damper spring. Do not compress the spring excessively.
6. Install the washer (A) and a new 10 mm self-locking nut (B). Hold the damper shaft with a hex wench (C), and tighten the 10 mm self-locking nut
to the specified torque value.
7. Remove the damper assembly from the strut spring compressor.
Installation
