TL V6-3.2L (2004)
Pressure Regulating Solenoid: Service and Repair
A/T Clutch Pressure Control Solenoid Valve A and B Replacement
A/T Clutch Pressure Control Solenoid Valve A and B Replacement
1. Make sure you have the customer's radio and navigation anti-theft codes, and write down the XM radio channel presets.
2. Remove the left side engine compartment cover.
3. Make sure the ignition switch is OFF. Disconnect the battery negative terminal, then disconnect the battery positive terminal.
4. Remove the battery hold-down bracket, then remove the battery and battery tray.
5. Remove the intake air duct and air cleaner housing.
6. Remove the transmission upper mount bracket (A) and bracket plate (B).
7. Remove the bolt securing the harness clamp bracket (C). Then remove the remaining bolts and A/T clutch pressure control solenoid valve A and
B.
8. Remove A/T clutch pressure control solenoid valve A and B, O-rings (D), 8 x 8 mm ATF feed pipes (E), gasket (F), and 8 x 40 mm ATF feed pipe
(G).
9. Place a new gasket on the transmission housing, then install the 8 x 18 mm ATF feed pipes with their filter side into the transmission housing.
10. Install new O-rings over the feed pipes, and install the 8 x 40 mm ATF feed pipe.
11. Install the new A/T clutch pressure control solenoid valve A and B, and harness clamp.
12. Check the A/T clutch pressure control solenoid valve A and B connectors for corrosion, dirt, and oil, then connect them securely.
13. Install the transmission upper mount bracket and bracket plate.
14. Install the air cleaner housing and intake air duct.
15. Install the battery tray, battery, and battery holddown bracket, then connect battery terminals.
16. Install the left side engine compartment cover.
17. Enter the radio and navigation anti-theft codes, and set the XM radio channel presets and the clock.
