TL V6-3.2L (2004)
8. Remove the bolts securing the shift cable holder (A), then remove the shift cable cover (B).
NOTE: To prevent damage to the control lever joint, remove the bolts securing the holder before removing the bolts securing the cover.
9. Remove the lock bolt (C) securing the control lever (D), then remove the shift cable and the control lever. Do not bend the shift cable excessively.
10. Insert the new shift cable through the grommet hole. Do not bend the shift cable excessively.
11. Install the shift cable bracket on the body, then install the grommet.
12. Verify that the transmission is in the R position at the control lever.
13. Install the control lever on the control shaft. Do not bend the shift cable excessively.
14. Install the lock bolt with a new lock washer, then bend the lock washer tab against the bolt head.
15. Install the shift cable cover, then secure the shift cable holder on the cover with the bolts.
NOTE: To prevent damage to the control lever joint, be sure install the shift cable holder after installing the shift cable cover to the torque
converter housing.
16. Install the heat shield.
17. Turn the ignition switch ON (II), and verify that the R position indicator comes on.
18. If necessary, push the shift cable until it stops, then release it. Pull the shift cable back one step so that the shift position is in R. Do not hold the
shift cable guide (A) to adjust the shift cable (B).
19. Turn the ignition switch OFF.
