TL V6-3.2L (2004)
1. Wrap the splines with vinyl tape (A) to prevent damage to the inboard boot.
2. Install the inboard boot onto the driveshaft, then remove the vinyl tape. Be careful not to damage the inboard boot.
3. Install the spider (A) onto the driveshaft by aligning the marks (B) on the spider and the end of the driveshaft.
4. Fit the circlip (C) into tine driveshaft groove. Rotate the circlip in its groove to make sure it is fully seated.
5. Fit the rollers (A) onto the spider (B) with their high shoulders facing outward, and note these items:
-
Reinstall the rollers in their original positions on the spider by aligning the marks (C).
-
Hold the driveshaft pointed up to prevent the rollers from falling off.
6. Pack the inboard joint with the joint grease included in the new driveshaft set.
Grease quantity Inboard joint: 150 - 160 g (5.3 - 5.6 oz)
