TL V6-3.2L (2004)
7. Pack the outboard joint (A) with the joint grease included in the new joint boot set.
Grease quantity
Outboard joint: 140 - 150 g (4.9 - 5.3 oz)
8. Adjust the length of the driveshafts to those shown in the figure, then adjust the boots to halfway between full compression and full extension.
Make sure the ends of the boots seat in the groove of the driveshaft and joint.
Right driveshaft: 512 - 517 mm (20.16 - 20.35 inch)
Left driveshaft: 554 - 559 mm (21.81 - 22.01 inch)
9. Fit the boot (A) ends onto the driveshaft (B) and outboard joint (C).
10. Close the ear portion (A) of the band with commercially available boot band pincers Kent-Moore J-35910 or equivalent (B).
