TL V6-3.2L (2004)
7. Fit the inboard joint onto the driveshaft, and note these items:
-
Reinstall the inboard joint onto the driveshaft by aligning the marks (A) on the inboard joint and the rollers.
-
Hold the driveshaft so the inboard joint is pointing up to prevent it from falling off.
8. Adjust the inboard joint so the rollers are in the middle of the joint, then check the driveshaft length measurement to those shown in the figure.
Right driveshaft: 512 - 517 mm (20.16 - 20.35 inch)
Left driveshaft: 554 - 559 mm (21.81 - 22.01 inch)
9. Install the boot bands.
-
For the double loop type, go to step 13 (Boot band replacement only)
-
For the low profile type, go to step 10.
10. Install the new low profile band (A) onto the boot (B), then hook the tab (C) of the band.
