TL V6-3.2L (2004)
20. Bend the band end (A) by tapping it down with a hammer.
NOTE:
-
Make sure the band and clip do not interfere with anything on the vehicle and the band does not move.
-
Remove any grease remaining on the surrounding surfaces
21. Repeat steps 13 through 20 for the band on the other end of the boot, then go to step 22.
22. Install the new set ring.
Outboard Joint Side
1. Wrap the splines with vinyl tape (A) to prevent damage to the outboard boot.
2. Install new ear clamp bands (B) and outboard boot, then remove the vinyl tape. Be careful not to damage the outboard boot.
