TL V6-3.2L (2004)
In addition, check for a punch mark above the fifth character of the engine compartment VIN. A punch mark in that location means this campaign has
already been completed.
Some vehicles affected by this campaign may be in your used vehicle inventory. According to federal law, these vehicles cannot be sold or leased until
they are repaired. To see if a vehicle is affected by this campaign, do a VIN status inquiry before selling or leasing it.
CORRECTIVE ACTION
*Inspect the windshield wiper motor and, depending on its condition, install a wiper motor kit or a wiper motor linkage assembly. If the inspection shows
that a countermeasured wiper motor has already been installed, no further action is needed.*
PARTS INFORMATION
Wiper Motor Kit: P/N 76503-SEP-305 (Includes snorkel tube and EPT seal)
Wiper Linkage Assembly: P/N 76500-SEP-A02 (Includes wiper motor and linkage):
WARRANTY CLAIM INFORMATION
Failed Part:
P/N 76505-SDA-A01
Defect Code:
5WMOO
Symptom Code:
Q7200
Skill Level:
Repair Technician
REPAIR PROCEDURE
1.
Turn the ignition switch to ON (II), and turn on the wipers:
^
If the wipers work, go to step 3.
^
If the wipers don't work, go to step 2.
*2.
Replace the wiper linkage assembly (includes the wiper motor):*
NOTE:
Torque the windshield wiper arm nuts to 30 N.m (22 lb-ft).
^
Refer to page 22-257 of the 04-06 TL Service Manual, or
^
Online, enter keyword WIPE and select Windshield Wiper Motor Replacement from the list.
Once the assembly is replaced, go to step 26.
3.
Remove the left and right rear engine compartment covers, the windshield wiper arms, the rear hood seal, and the cowl covers:
^
Refer to steps 1 thru 3 on page 22-257 of the 04-06 TL Service Manual, or
^
Online, enter keyword WIPE, select Windshield Wiper Motor Replacement from the list, and do only steps 1 thru 3 of that procedure.
4.
Check the part number on the wiper motor:
*
^
If the part number ends with A020 (see below), a countermeasured wiper motor is already installed; go to step 24.
