TL V6-3.5L (2007)
Cabin Noise Sensor: Service and Repair
Active Noise Control Microphone Removal/Installation
Type-S model front
1. Remove the roof console and disconnect the connector (A).
2. Using a T25 TORX bit, remove the screws, then remove the active noise control front microphone (B).
3. Install the microphone in the reverse order of removal.
Type-S model rear
1. Remove the headliner.
2. Disconnect the connector (A), then remove the screws and the active noise control rear microphone (B) and cap (C).
3. Install the microphone in the reverse order of removal.
