TL V6-3.5L (2007)
NOTE: The tie down hook slots use rubber plugs to cover the openings.
Front Towing Hook Installation
1. Remove the cover (A) from the front bumper.
2. Remove the towing hook, hook extension, and wheel wrench from the tool case in the spare tire.
3. Using the wheel wrench, fasten the extension (B) into the bolt hole in the bumper.
4. Screw the towing hook (A) into the extension, and tighten it securely by hand.
Wheel Lift Equipment - The tow truck uses two pivoting arms that go under the tires (front or rear) and lift them off the ground. The other two wheels
remain on the ground. This is an acceptable way of towing the vehicle.
Sling-type Equipment - The tow truck uses metal cables with hooks on the ends. These hooks go around parts of the frame or suspension, and the
cables lift that end of the vehicle off the ground. The vehicle's suspension and body can be seriously damaged if this method of towing is attempted. Do
not use this method of towing.
If the vehicle cannot be transported by a flat-bed, it should be towed with the front wheels off the ground. If the vehicle is damaged, and the vehicle must
be towed with the front wheels on the ground, do this:
Manual Transmission
-
Release the parking brake.
-
Shift the transmission to neutral.
-
Leave the ignition switch in the ACCESSORY (I) position so the steering wheel does not lock.
-
Make sure all accessories are turned off to minimize battery current draw.
Automatic Transmission
-
Release the parking brake.
-
Start the engine.
-
Shift to the D position, then to the N position.
-
Turn off the engine.
-
Leave the ignition switch in the ACCESSORY (I) position so the steering wheel does not lock.
-
Make sure all accessories are turned off to minimize battery current draw.
It is best to tow the vehicle no farther than 50 miles (80 km), and keep the speed below 35 mph (55 km/h).
NOTE:
