TL V6-3.5L (2007)
2. Release the hooks (D) and clip (E), then remove the power window switch panel.
8. Remove the screws (A), then remove the door trim (B).
9. Remove the inner handle (A) by releasing the hook (B).
10. Install the door panel in the reverse order of removal, and note these items:
-
Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
-
Make sure the connectors are plugged in properly, and the cable is connected properly.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
-
Check for water leaks.
-
Make sure the window and power door lock operate properly.
-
Reset the power window control unit on the door that the panel was removed from.
