TL V6-3.5L (2007)
Trim Panel: Service and Repair
Trim Removal/Installation - Door Areas
Trim Removal/Installation - Door Areas
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
Front Door Sill Area
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Take care not to bend or scratch the trim and panels.
1. Driver's side: Remove the footrest.
2. Remove the driver's kick panel (A) or the passenger's kick panel (B).
1. Pull out the front door opening trim (C) from the kick panel hooks (D) and the front door opening flange.
2. Driver's side: Pull the hood opener knob (E) and hold it.
3. Pull the kick panel back by hand to detach the clips (F, G), and to release the hook (H) and tab (I) from the front door sill trim (J), then remove
