TL V6-3.5L (2007)
6. Fold the mirror to front, then remove the screws and housing (A).
7. Fold the mirror to rear, then remove the housing (A).
Installation
8. Route the wire harness of the new actuator through the hole in the bracket and gasket.
9. Install the actuator, bracket, harness grommet, and gasket in the reverse order of removal.
10. Install the new actuator terminals into the connector in the original arrangement as shown.
11. Reassemble in the reverse order of disassembly. Be careful not to break the mirror holder when reinstalling it to the actuator.
12. Reinstall the mirror assembly to the door.
13. Operate the power mirror to ensure smooth operation.
