TL V6-3.5L (2007)
5. Cut two 10 mm x 25 mm pieces of felt. Apply the felt between the two rivets on the bottom of the seat track.
6. Attach the seat weight sensor assemblies to the seat track using new TORX bolts. Tighten the bolts by hand.
7. Place the seat in position, and hand-tighten the anchor bolts. Do not torque the bolts.
8. Center the outer weight sensor on the seat track:
^
Push the sensor outward, and mark the position of the bolt head.
^
Push the sensor inward, and mark the position of the bolt head.
^
Center the bolt between the two marks, then torque the bolt to 14 N.m (10 lb-ft).
9. Repeat step 8 for the inner weight sensor.
10. Torque the remaining four TORX bolts to 25 N.m (18 lb-ft).
11. Install the remaining parts in the reverse order of removal. Torque the anchor bolts to 34 N.m (25 lb-ft).
12. Reconnect the negative cable to the battery.
