TL V6-3.5L (2007)
Brake Bleeding: Service and Repair
Brake System Bleeding
NOTE:
^
Do not reuse the drained fluid. Use only clean Acura DOT 3 Brake Fluid from an unopened container. Using a non-Acura brake fluid can cause
corrosion and shorten the life of the system.
^
Do not mix different brands of brake fluid; they may not be compatible.
^
Make sure no dirt or other foreign matter is allowed to contaminate the brake fluid.
^
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
^
The reservoir on the master cylinder must be at the MAX (upper) level mark at the start of the bleeding procedure and checked after bleeding each
brake caliper. Add fluid as required.
^
Front caliper for the Type S model (4-piston caliper type); do this by first bleeding the outside piston of the front caliper. Then bleed the inside
piston of the front caliper.
1. Make sure the brake fluid level in the reservoir is at the MAX (upper) level line (A).
2. Slide a piece of clear plastic hose over the first bleed screw, and submerge the other end in a container of new brake fluid.
3. Have someone slowly pump the brake pedal several times, then apply steady pressure.
4. Loosen the left-front brake bleed screw, loosen the brake bleed screw to allow air to escape from the system. Then tighten the bleed screw
securely.
NOTE:
^
The bleed valve uses an 11 mm hex wrench on the Type S model.
^
On Type S model: Bleed the outside piston of the front caliper first, then bleed the inside piston.
5. Repeat the procedure for each caliper until no air bubbles are in the fluid. Bleed the calipers in the sequence shown.
