TL V6-3.5L (2007)
-1 Hold the pulley with the holder handle (A) and holder attachment (B). Torque the bolt to 65 Nm (6.5 kgf-m, 47 lbf-ft) with a torque wrench
and heavy duty 19 mm socket (C).
-2 Mark the bolt head (D) and crankshaft pulley (E) as shown, then tighten the bolt an additional 60° (The mark on the bolt head lines up with
the mark on the crankshaft pulley).
3. Install the drive belt.
4. Install the splash shield.
5. Install the right front wheel.
NOTE: On J35A8 engine, be careful not to damage or chip the paint of the brake calipers when installing the wheel.