TL V6-3.5L (2007)
Timing Belt: Service and Repair
Timing Belt Removal
Timing Belt Removal
1. Remove the right side engine compartment cover.
2. Turn the crankshaft so its white mark (A) on the crankshaft pulley lines up with the pointer (B).
3. Check that the No. 1 piston top dead center (TDC) mark (A) on the front camshaft pulley and the pointer (B) on the front upper cover are aligned.
NOTE: If the marks are not aligned, rotate the crankshaft 360°, and recheck the camshaft pulley mark.
4. Remove the right front wheel.
5. Remove the splash shield.
6. Remove the drive belt.
7. Support the engine with a jack and wood block under the oil pan.
8. Remove the ground cable (A), then remove the upper half of the side engine mount bracket (B).