TL V6-3.5L (2007)
Control Assembly: Service and Repair
Audio-HVAC Display Module Assembly Removal/Installation
Audio-HVAC Display Module Assembly Removal/Installation
SRS components are located in this area. Review the SRS component locations, and the precautions and procedures before performing repairs or service.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to scratch the dashboard and related parts.
-
Lay a workshop towel under the parts when working on them to protect the face panel from scratches or other damage.
1. Make sure you have the anti-theft codes for the audio and navigation system, then write down the audio presets.
2. Remove the center console trim and center console panel.
3. Remove the dashboard center vent.
4. Remove the bolts, then pull out the audio-HVAC display module assembly (A).
5. Disconnect the connectors (B, C), then remove the audio-HVAC display module assembly.
6. Install the audio-HVAC display module assembly in the reverse order of removal, and note these items:
-
Make sure all connectors and AM/FM antenna sublead are secure.
-
Enter the anti-theft code for the audio, then enter the audio presets, and set the clock.
-
If necessary, enter the navigation system anti-theft code.
