TL V6-3.5L (2007)
Data Link Connector: Testing and Inspection
Part 1
DLC Circuit Troubleshooting (Part 1)
NOTE: Before you begin, make sure the HDS and its DLC cable are working properly.
1. Turn the ignition switch OFF.
2. Connect the HDS to the DLC.
3. Turn the ignition switch ON (II), and read the HDS.
Does the HDS identify the vehicle?
YES - Go to step 4.
NO - Go to step 20.
4. Check for Temporary DTCs or DTCs in the PGM-FI system with the HDS.
Are any Temporary DTCs or DTCs indicated?
YES - Go to the indicated DTCs troubleshooting.
NO - Go to step 5.
5. Turn the ignition switch OFF.
6. Turn the ignition switch ON (II), and watch the SRS indicator.
Does the SRS indicator stay on?
YES - Go to the SRS system's general troubleshooting information.
NO - Go to step 7.
7. Turn the ignition switch OFF.
8. Turn the ignition switch ON (II), and watch the TPMS indicator.
Does the TPMS indicator stay on?
YES - Go to the TPMS system's general troubleshooting information.
NO - Go to step 9.
9. Turn the ignition switch OFF.
10. Turn the ignition switch ON (II), and watch the VSA indicator.
Does the VSA indicator stay on?
YES - Go to the VSA system's general troubleshooting information.
NO - Go to step 11.
11. Turn the ignition switch OFF.
12. Turn the ignition switch ON (II), and watch the immobilizer indicator.
Does the immobilizer indicator stay on or flash?
YES - Go to the immobilizer system's troubleshooting.
NO - Go to step 13.
13. Check for B-CAN system DTCs without the HDS.
Are any B-CAN DTCs indicated?
YES - Go to the indicated DTCs troubleshooting.
