TL V6-3.5L (2007)
Camshaft Position Sensor: Service and Repair
CMP Sensor Replacement
1. Set the No. 1 piston at top dead center.
2. Remove the crankshaft pulley.
3. Remove the upper and lower front covers from the engine.
4. To hold the timing belt adjuster in its current position, thread in the battery clamp bolt (hand-tight).
5. Loosen the idler pulley bolt about five or six turns, then remove the timing belt from the front camshaft pulley.
6. Remove the front camshaft pulley (A).
7. Disconnect the CMP sensor 3P connector (B), then remove the back cover (C).
8. Remove the CMP sensor (A) from the back cover.
9. Install the parts in the reverse order of removal, then install the timing belt.
10. Do the CKP pattern clear/pattern learn procedure.
