TL V6-3.5L (2007)
19. Check the fluid passage of the solenoid valve for contamination.
20. Connect a jumper wire from the negative battery terminal to A/T clutch pressure control solenoid valve B connector terminal No. 2, and connect a
jumper wire from the positive battery terminal to connector terminal No. 1. Make sure A/T clutch pressure control solenoid valve B moves.
21. Disconnect one of the jumper wires and check the valve movement at the fluid passage in the valve body mounting surface. If the valve binds or
moves sluggishly, or if the solenoid valve does not operate, replace A/T clutch pressure control solenoid valves A and B.
22. Clean the mounting surfaces and the fluid passages of the solenoid valve body and the solenoid valve cover.
23. Install the new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing.
Install the new O-rings over the ATF pipes,
24. Install A/T clutch pressure control solenoid valves A and B.
25. Secure the harness cover with the bolt.
26. Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely.
27. Apply molybdenum grease to the bore hole of synthetic resin bushing in the shift cable end, and attach the shift cable end to the control lever, then
insert the control pin into the control lever hole through the shift cable end, and secure the control pin with the spring clip/washer.
28. Secure the shift cable bracket with the nuts.
29. Install the battery base.
30. Install the intake air duct and air cleaner assembly.
31. Install the battery tray, battery, and battery hold down bracket, then connect the battery terminals.
32. Install the left upper fender cover and battery trim.
33. Enter the anti-theft codes for the audio system and the navigation system (if equipped), then enter the audio presets.
