TL V6-3.5L (2007)
5. Check for continuity between each ignition coil 3P connector terminal No. 2 and the body ground.
Is there continuity?
YES - Go to step 6.
NO - Repair open in the wire between ignition coil 3P connector terminal No. 2 and the body ground.
6. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC).
7. Turn the ignition switch ON (II).
8. Make sure the HDS communicates with the vehicle and the engine control module (ECM)/powertrain control module (PCM). If it doesn't
communicate, troubleshoot the DLC circuit.
9. Jump the SCS line with the HDS, then turn the ignition switch OFF.
NOTE: This step must be done to protect the ECM/PCM from damage.
10. Disconnect ECM/PCM connector E (31P).
11. Check for continuity between ignition coil relay 4P socket terminal No. 3 and body ground.
Is there continuity?
YES - Repair short in the wire between ignition coil relay 4P socket terminal No. 3 and the ECM/PCM
12. Check for continuity between ignition coil relay 4P socket terminal No. 3 and ECM/PCM connector terminal E5.
