TL V6-3.5L (2007)
Impact Sensor: Service and Repair
Side Impact Sensor (Second) Replacement
Side Impact Sensor (Second) Replacement
Removal
1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
2. Disconnect the appropriate side curtain airbag 2P connector.
3. Disconnect the side impact sensor (second) 2P connector (A) from the side curtain airbag harness.
4. Using a TORX T30 bit, remove the TORX bolts (B), then remove the side impact sensor (second) (C).
Installation
1. Install the new side impact sensor (second) (A) with TORX bolts (B) then connect the side curtain airbag harness 2P connector (C) to the side
impact sensor.
2. Reconnect the negative cable to the battery.
3. Install all removed parts.
4. After installing the side impact sensor (second), confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come
on for about 6 seconds and then go off.
