TL V6-3.5L (2007)
Seat Occupant Sensor: Service and Repair
Driver's Seat Position Sensor
Driver's Seat Position Sensor Replacement
Removal
NOTE:
-
Removal of the driver's seat position sensor must be performed according to SRS the precautions/procedures.
-
Before disconnecting the driver's seat position sensor 2P connector, disconnect the driver's airbag 4P connector.
-
Do not turn the ignition switch ON (II), and do not connect the battery cable while removing the driver's seat position sensor.
1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
2. Disconnect the driver's airbag 4P connector.
3. Remove the driver's seat assembly.
4. Remove the bolt and nut from the inner seat track of the driver's seat linkage.
5. Remove the driver's seat position sensor.
Installation
NOTE:
-
Be sure to install the harness wires so they are not pinched or interfering with other parts.
-
Do not turn the ignition switch ON (II), and do not connect the battery cable while installing the driver's seat position sensor.
-
After installing the driver's seat position sensor, make sure it is clean. Keep it away from dust.
1. Install the new driver's seat position sensor, then connect the driver's seat position sensor harness 2P connector to the driver's seat position sensor
(A).
2. Install the driver's seat assembly.
3. Reconnect the negative cable to the battery.
4. Check the operation of the driver's seat position sensor with the HDS.
