TL V6-3.5L (2007)
15. Install the armature in the housing. Next, pry back each brush spring again, and push each brush down until it seats against the commutator, then
release the spring against the end of the brush.
16. Install the starter end cover (A) to retain the brush holder (B).
Overrunning Clutch Inspection
17. Slide the overrunning clutch along the shaft. Replace it if it does not slide smoothly.
18. Rotate the overrunning clutch (A) both ways. If it does not lock in either direction, or it locks in both directions, replace it.
19. If the starter drive gear (B) is worn or damaged, replace the overrunning clutch assembly; the gear is not available separately.
NOTE: Check the condition of the flywheel ring gear to see if the teeth are damaged.
20. Reassemble the starter in the reverse order of disassembly.