TL V6-3.5L (2007)
10. Measure steady-state fluid pressure while the engine is idling. If the pump is in good condition, the gauge should read no more than 1,470 kPa
(15 kgf/cm2, 213 psi). If it reads high, check for:
^
Clogged or deformed feed or return line between the pump and gearbox.
^
Clogged valve body unit.
11. Close the shut-off valve, then close the pressure control valve gradually until the pressure gauge needle is stable. Read the pressure.
NOTICE: Do not keep the shut-off valve closed more than 5 seconds or the pump could be damaged by over-heating.
12. Immediately open the shut-off valve fully. If the pump is in good condition, the gauge should read at least 7,940-8,630 kPa (81-88 kgf/cm2,
1,150-1,250 psi). A low reading means pump output is too low for full assist. Repair or replace the pump.