TL V6-3.5L (2007)
Steering Wheel: Service and Repair
Steering Wheel Installation
Steering Wheel Installation
1. Before installing the steering wheel, make sure the front wheels are aligned straight ahead, then center the cable reel (A). Do this by first rotating
the cable reel clockwise until it stops. Then rotate it counterclockwise about three full turns. The arrow mark (B) on the cable reel label point
should point straight up.
2. Position the two tabs (A) of the turn signal canceling sleeve (B) as shown. Install the steering wheel on to the steering column shaft, making sure
the steering wheel hub (C) engages the pins (D) of the cable reel and tabs of the turn signal canceling sleeve. Do not tap on the steering wheel or
steering column shaft when installing the steering wheel.
3. Install the steering wheel bolt (A) and tighten it to the specified torque Connect the cable reel subharness connector. Make sure the wire harness is
routed and fastened properly.
4. Install the driver's airbag, and confirm that the system is operating properly.
5. Reconnect the negative cable to the battery, and do these items:
^
Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
^
Enter the anti-theft code for the audio or the navigation system, then enter the audio presets. Set the clock. Check the horn and turn signals for
proper operation. Make sure the steering wheel switches work properly. Make sure the steering wheel is centered.
