TL V6-3.5L (2007)
5. With a 1/2 inch drive impact wrench, tighten the pressure bolt until the ball joint pin pops loose from the ball joint pin hole. If necessary, slightly
raise the boot and apply penetrating type lubricant to help loosen the ball joint pin.
NOTE: Do not hammer on the tool or arm at anytime. Do not use the impact to back-off the pressure bolt once the ball joint is popped. Doing so
could damage the threads on the pressure bolt.
6. Remove the special tools from the knuckle and the end of the ball joint pin, and pull the ball joint out of the ball joint pin hole. Inspect the ball
joint boot, and replace it if damaged.
NOTE: If the ball joint collar/sleeve comes loose, you must replace the lower arm.
