TL V6-3.5L (2007)
12. Disconnect the tie-rod end ball joint from the knuckle using the ball joint remover.
13. Remove the cotter pin (A) from the lower arm ball joint, and remove the nut (B).
NOTE:
^
To avoid damaging the ball joint, install the ball joint thread protector on the threads of the ball joint.
^
Be careful not to damage the ball joint boot when installing the remover.
^
Do not force or hammer on the lower arm, or pry between the lower arm and the knuckle. You could damage the ball joint.
^
Insert the new cotter pin into the ball joint pin hole from the front to the rear of the vehicle, and bend its end as shown.
^
During installation, install a new cotter pin after tightening a new nut.
14. Disconnect the lower ball joint from the lower arm using the ball joint thread protector, and the ball joint remover.
NOTE: If the collar/sleeve on the lower arm is removed with ball joint, the lower arm must be replaced.
15. Remove the cotter pin (A) from the upper arm ball joint, then loosen the nut (B).
NOTE: During installation, insert a new cotter pin into the ball joint pin from the front to the rear of the vehicle, and bend its end as shown.
