TL V6-3.5L (2007)
Rear Knuckle Alignment Link: Service and Repair
Knuckle Replacement
Knuckle Replacement
1. Remove the hub bearing unit.
2. Remove the wheel sensor (A) from the knuckle. Do not disconnect the wheel sensor connector.
3. Remove the lock pin (A) from the upper arm ball joint, then loosen the nut (B).
NOTE: During installation, install the lock pin as shown after tightening the nut.
4. Disconnect the upper arm ball joint from the knuckle using the ball joint remover.
5. Remove the flange nut (A) while holding the joint pin (B) with a hex wrench (C), then disconnect the stabilizer link (D) from the stabilizer link
bracket (E).
6. Remove the damper lower mounting bolt (F), and disconnect the damper from the knuckle.
NOTE: During installation, install a new damper lower mounting bolt.