TL V6-3.5L (2007)
13. Remove the lower arm mounting bolt (A), then remove the knuckle (B).
NOTE: During installation, install a new lower arm mounting bolt and nut.
14. Install the knuckle in the reverse order of removal, and note these items:
^
Be careful not to damage the ball joint boot when installing the knuckle.
^
Tighten all mounting hardware to the specified torque values.
^
First install all the components and lightly tighten the bolts and nuts, then raise the suspension to load it with the vehicle's weight before fully
tightening to the specified torque values.
^
Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the ball joint pin hole. Do not align
the castle nut by loosening it.
^
Before installing the wheel, clean the mating surface on the brake disc/drum and the inside of the wheel.
^
Check the wheel alignment, and adjust it if necessary.
