TL V6-3.5L (2007)
2. Install the damper fork (A) over the driveshaft and onto the lower arm. Install the front damper in the damper fork so the aligning tab (B) is
aligned with the slot (C) in the damper fork.
3. Loosely install the damper pinch bolt (D) into the damper fork.
4. Install anew flange bolt (E) to the damper fork and lower arm, then lightly tighten a new damper fork mounting nut (F).
5. Place the floor jack under the lower arm, and raise the suspension to load it with the vehicle's weight.
6. Tighten the flange nuts on the top of the damper to the specified torque values.
7. Tighten the damper pinch bolts to the specified torque value.
8. Tighten the flange nut on the damper fork to the specified torque value.
9. Clean the mating surface of the brake disc and the inside of the wheel, then install the front wheel.
10. Install the strut brace (A) with the vehicle on the ground.
11. Install the engine compartment covers (B).
12. Check the wheel alignment, and adjust it if necessary.
