TL V6-3.5L (2007)
16. Disconnect the upper arm ball joint from the knuckle using the ball joint remover.
17. Remove the driveshaft outboard joint (A) from the knuckle (B) by tapping the driveshaft end (C) with a plastic hammer while drawing the hub
outward, then remove the knuckle.
NOTE:
^
Do not pull the driveshaft end outward. The inner driveshaft joint may come apart.
^
During installation, apply grease to the mating surface of the wheel bearing and the driveshaft outboard joint.
18. Install the knuckle/hub in the reverse order of removal, and note these items:
^
Be careful not to damage the ball joint boot when installing the knuckle.
^
Tighten all mounting hardware to the specified torque values.
^
Before connecting the lower ball joint to the lower arm, degrease the threaded section and tapered portion of the ball joint pin, the lower arm
connecting hole, the threaded section and mating surface of the castle nut.
^
First install all the components and lightly tighten the bolts and nuts, then raise the suspension to load it with the vehicle's weight before fully
tightening to the specified torque values. Do not place the jack against the ball joint pin of the knuckle.
^
Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the ball joint pin hole. Do not align
the castle nut by loosening it.
^
Use a new spindle nut during reassembly.
^
Before installing the spindle nut, apply a small amount of engine oil to the seating surface of the nut. After tightening, use a drift to stake the
spindle nut shoulder against the driveshaft.
^
Before installing the brake disc, clean the mating surface of the front hub and the inside of the brake disc.
^
Before installing the wheel, clean the mating surface of the brake disc and the inside of the wheel.
^
Take care not to scratch the front calipers on Type S model when installing the front wheels.
^
Check the front wheel alignment, and adjust if necessary.
Wheel Bearing Replacement
1. Separate the hub ON) from the knuckle (B) using the hub dis/assembly tool and a hydraulic press. Hold the knuckle with the attachment (C) of the
hydraulic press or equivalent tool. Be careful not to deform the splash guard. Hold onto the hub to keep it from failing when pressed clear.
