TL V6-3.5L (2007)
Wheel Fastener: Service and Repair
Wheel Bolt Replacement
NOTICE:
^
Do not use a hammer or air or electric impact tools to remove and install the wheel bolts.
^
Be careful not to damage the threads of the wheel bolts.
1. Remove the front hub or rear hub bearing unit front.
2. Separate the wheel bolt (A) from the hub (B) using a hydraulic press. Support the hub with hydraulic press attachment (C) or equivalent tools.
NOTE:
^
Before installing the new wheel bolt, clean the mating surface on the bolt and the hub.
^
The illustration shows a front hub.
3. Insert the new wheel bolt into the hub while aligning the splined surfaces on the hub hole with the wheel bolt.
NOTE:
^
Degrease all around the wheel bolt and the threaded section of the nut.
^
Make sure the wheel bolt is installed vertically in relation to the hub disc surface.
^
Do not install the nut and washers that have been used as tools on a vehicle.
4. Tighten the nut until the wheel bolt is drawn fully into the hub. Don't exceed the maximum torque limit. Make sure there is no gap between the bolt
and the hub.
Limited torque: 108 N-m (11.0 kgf-m, 79.6 lbf-ft)
5. Install the front hub or rear hub bearing unit.
NOTE: If you cannot tighten the wheel nut to the specified torque value when installing the wheel, replace the front hub or rear hub bearing unit
as an assembly.
