TL V6-3.5L (2007)
13. Check the fluid passage of the A/T clutch pressure control solenoid valve for dust and dirt, and clean the passage if necessary.
14. Install the new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing.
Install new O-rings over the ATF pipes.
15. Install A/T clutch pressure control solenoid valves A and B.
16. Secure the harness cover with the bolt.
17. Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely.
18. Apply molybdenum grease to the bore hole of synthetic resin bushing in the shift cable end, and attach the shift cable end to the control [ever, then
insert the control pin into the control lever hole through the shift cable end, and secure the control pin with the spring clip/washer.
19. Secure the shift cable bracket with the nuts.
20. Install the battery base.
21. Install the intake air duct and air cleaner assembly.
22. Install the battery tray, battery, and battery hold down bracket, then connect battery terminals.
23. Install the left upper fender cover and battery trim.
24. Enter the anti-theft codes for the audio system and the navigation system (if equipped), then enter the audio presets.
