TL V6-3.5L (2007)
10. Remove the ATF joint pipes, O-rings, ATF pipe, and gasket.
11. Check the fluid passage of the solenoid valve for contamination.
12. Connect a jumper wire from the negative battery terminal to A/T clutch pressure control solenoid valve C connector terminal No. 2, and connect a
jumper wire from the positive battery terminal to connector terminal No. 1. Make sure A/T clutch pressure control solenoid valve C moves.
13. Disconnect one of jumper wires and check the valve movement at the fluid passage in the valve body mounting surface. If the valve binds or
moves sluggishly, or if the solenoid valve does not operate, replace A/T clutch pressure control solenoid valve C.
14. Clean the mounting surfaces and the fluid passages of the solenoid valve body and the transmission housing.
15. Install the 8 x 53 mm ATF joint pipe (A) with the filter side into its mounting hole (B).
16. Check the height (A) of the 8 x 53 mm ATF joint pipe (B) between the top (C) of the pipe and the solenoid valve body mounting surface (D). The
height is about 7 mm (0.3 in.). If the height is over 7 mm (0.3 in.), push the pipe until it bottoms in the accumulator body.