TL V6-3.5L (2007)
21. Measure the resistance between each connector terminal of the shift solenoid valve and body ground.
Standard: 12-25 Ohms
^
If the resistance is out of standard, go to step 24 and replace the shift solenoid valve.
^
If the resistance is within the standard, go to step 22 and check solenoid valve for a clicking sound.
22. Connect a jumper wire from the negative battery terminal to body ground, and connect a jumper wire from the positive battery terminal to each
solenoid terminal individually.
^
If a clicking sound is heard, go to step 23 and replace the solenoid harness.
^
If no clicking sound is heard, go to step 24 and replace the shift solenoid valve.
23. Remove the solenoid harness, and install a new O-ring (A) on the solenoid harness connector (B), and install the connector in the transmission
housing, then go to step 30.
24. Remove the mounting bolts, then remove the solenoid valves.
