TL V6-3.5L (2007)
7. Raise the stake (A), then remove the spindle nut (B).
8. Remove the brake disc retaining screws (A).
9. Screw two 8 x 1.25 mm bolts (B) into the disc to push it away from the hub. Turn each bolt two turns at a time to prevent cocking the disc
excessively.
10. Remove the brake, disc (C) from the hub.
11. Remove the cotter pin (A) from the tie-rod end ball joint, then loosen the nut (B).
NOTE: During installation, install the new cotter pin after tightening the nut, and bend its end as shown.