TL V6-3.5L (2007)
8. Remove the hub bearing unit (A).
9. Install the hub bearing unit in the reverse order of removal, and note these items:
^
Tighten all mounting hardware to the specified torque values.
^
Use a new spindle nut on reassembly.
^
Wash the spindle thoroughly in high flash point solvent before reassembly.
^
Before installing the spindle nut, apply a small amount of engine oil to the seating surface of the nut. After tightening, use a drift to stake the
spindle nut shoulder against the driveshaft.
^
Before installing the brake disc/drum, clean the mating surfaces of the hub bearing unit and brake disc/drum.
^
Before installing the wheel, clean the mating surfaces of the brake disc/drum and the inside of the wheel.
^
Check the wheel alignment, and adjust it if necessary.
