TL V6-3.5L (2007)
Transmission Position Switch/Sensor: Testing and Inspection
Transmission Range Switch Test
Transmission Range Switch Test
1. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped), and write down the audio presets.
2. Remove the battery trim and left upper fender cover.
3. Disconnect the negative terminal from the battery, then disconnect the positive terminal.
4. Remove the battery hold-down bracket, and remove the battery and battery tray.
5. Remove the intake air duct and air cleaner assembly.
6. Remove the battery base.
7. Disconnect the transmission range switch connector.
8. Check for continuity between the terminals at the switch connector. There should be continuity between the terminals in the following table for
each switch position.
9. The transmission range switch test is finished if the test results are OK. If there is no continuity between any terminals, check that transmission
range switch installation. If the switch installation is OK, replace the switch.
10. Check the connector for rust, dirt, or oil, clean or repair if necessary, then connect the connector securely.
11. Install the battery base.
12. Install the intake air duct and air cleaner assembly.
13. Install the battery tray, battery, and battery hold down bracket, then connect battery terminals.
14. Install the left upper fender cover and battery trim.
15. Enter the anti-theft codes for the audio system and the navigation system (if equipped), then enter the audio presets.
