TL V6-3.5L (2007)
Pressure Regulating Solenoid: Testing and Inspection
A/T Clutch Pressure Control Solenoid Valve C Test
A/T Clutch Pressure Control Solenoid Valve C Test
1. Connect the HDS to the DLC (A).
2. Choose Clutch Pressure Control (Linear) Solenoid C in Miscellaneous Test Menu on the HDS,
3. Test A/T clutch pressure control solenoid valve C with the HDS.
^
If the valve tests OK, the test is complete. Disconnect the HDS.
^
If the valve does not test OK, follow the instructions on the HDS.
^
If the valve does not test OK, and the HDS does not determine the cause, go to step 4.
4. Remove the battery trim and left upper fender cover.
5. Remove the intake air duct and air cleaner assembly.
6. Disconnect the A/T clutch pressure control solenoid valve C connector.
7. Measure the resistance between A/T clutch pressure control solenoid valve C connector terminals No. 1 and No. 2.
Standard: 3-10 Ohms
^
If the resistance is out of standard, replace the A/T clutch pressure control solenoid valve C.
^
If the resistance is within the standard, go to step 8.
8. Connect a jumper wire from the negative battery terminal to solenoid valve C connector terminal No. 2 and connect a jumper wire from the
positive battery terminal to connector terminal No. 1.
^
If a clicking sound is heard, the valve is OK. Reconnect the Connector, and install all removed parts.
^
If no clicking sound is heard, go to step 9.
9. Remove A/T clutch pressure control solenoid valve C.
