TL V6-3206cc 3.2L SOHC MFI (1998)
Lifter / Lash Adjuster: Service and Repair
BLEEDING
1. Fill a container with 10W - 30 engine oil and place the hydraulic tappet in it. Press down on the check ball with a thin wire. Bleed the tappet of air
by pumping the plunger slowly until no bubbles come out of the hydraulic tappet.
2. Install the hydraulic tappet to the rocker arm.
NOTE:
-
Use a new O-ring when reassembling.
-
Apply oil to the O-ring before installation.
