TL V6-3206cc 3.2L SOHC MFI (1998)
Piston Ring: Service and Repair
END GAP
1. Using a piston, push a new ring into the cylinder bore 15 - 20 mm (0.6 - 0.8 inch) from the bottom.
2. Measure the piston ring end-gap with a feeler gauge:
-
If the gap is too small, check to see if you have the proper rings for your engine.
-
If the gap is too large, recheck the cylinder bore diameter against the wear limits. If the bore is over the service limit, the cylinder block must
be rebored.
REPLACEMENT
1. Using a ring expander, remove the old piston rings.
2. Clean all ring grooves thoroughly.
NOTE:
-
Use a squared-off broken ring or ring groove cleaner with blade to fit the piston grooves. File down blade if necessary.
-
Top and 2nd ring grooves are 1.2 mm (0.05 inch) wide and oil ring groove is 2.8 mm (0.11 inch) wide.
CAUTION: Do not use a wire brush to clean the ring grooves, or cut ring grooves deeper with the cleaning tool.
NOTE: If the piston is to be separated from the connecting rod, do not install new rings yet.
