TL V6-3206cc 3.2L SOHC MFI (1998)
^ Be careful not to damage the pulley and compressor during removal/installation.
^ Once the snap ring B is removed, replace it with a new one.
4. Remove the screw from the field coil ground terminal. Remove the snap ring A with snap ring pliers, then remove the field coil.
NOTE:
^ Be careful not to damage the field coil and compressor during removal/installation.
^ Once the snap ring A is removed, replace it with a new one.
5. Install in the reverse order of removal. Make note of the following items.
^ Install the field coil with the wire side facing down (see figure).
^ Clean the pulley and compressor sliding surfaces with non-petroleum solvent.
^ Make sure the snap rings are fully seated in the groove.
^ Apply locking agent to the threads of the center bolt, and tighten it securely.
^ Make sure that the pulley turns smoothly after it's reassembled.