TL V6-3206cc 3.2L SOHC MFI (1998)
7. Remove the caliper bracket mounting bolts, and hang the caliper assembly to one side.
CAUTION: To prevent accidental damage to the caliper or brake hose, use a short piece of wire to hang the caliper from the under-carriage.
8. Remove the 6 mm brake disc retaining screws.
9. Screw two 8 x 12 mm bolts into the disc to push it away from the hub.
NOTE: Turn each bolt two turns at a time to prevent cocking the disc excessively.
CAUTION: Be careful not to damage the ball joint boot.
10. Clean any dirt or grease off the ball joint.
11. Remove the cotter pin from the ball joint castle nut, and remove the nut.
12. Install a 12 mm hex nut on the ball joint. Be sure that the 12 mm hex nut is flush with the ball joint pin end to prevent damage to the threaded end
of the ball joint.
13. Apply grease to the special tool on the areas shown. This will ease installation of the tool and prevent damage to the pressure bolt threads.
