TL V6-3206cc 3.2L SOHC MFI (1998)
10. Drill a 3 mm (0.12 inch) diameter hole approximately 2.5 - 3.0 mm (0.10 - 0.12 inch) in depth in the staked-point on the cylinder.
NOTE:
-
Do not allow metal shavings to enter the cylinder housing.
-
After removing the cylinder end, remove any burrs at the stake point.
11. Install the special tool to the steering gearbox housing. Clamp the tool in a vise with soft jaws as shown, then loosen and remove the cylinder end.
CAUTION: Do not clamp the cylinder housing.
12. Set the steering gearbox in a press-box so the gearbox housing points upward.
13. Insert a 6" long, 3/8" drive extension into the special tool.
14. Press the cylinder end seal and steering rack out of the gearbox.
NOTE: Hold the steering rack to keep it from falling when pressed clear.
CAUTION: Be careful not to damage to inner surface of the cylinder housing with the tool.