TL V6-3206cc 3.2L SOHC MFI (1998)
1. If removed the rubber stop; position the new rubber stop in the gearbox housing, then press it in using a hydraulic press and the special tools as
shown.
NOTE: Make sure that the special tool presses against the metal portion of the rubber stop.
2. Coat the piston seal ring guide with power steering fluid, and slide it onto the rack, big end first.
3. Position the new O-ring and new piston seal ring on the special tool, then slide them down toward the big end of the tool.
NOTE:
-
Do not over expand the resin seal rings. Install the resin seal rings with care so as not to damage them. After installation, be sure to contract the
seal ring using the special tool (sizing tool).
-
Replace piston's O-ring and seal ring as a set.
4. Pull the O-ring off into the piston groove, then pull the piston seal ring off into the piston groove on top of the O-ring.
5. Coat the piston seal ring and the inside of the special tool with power steering fluid.
6. Carefully slide the tool onto the rack and over the piston seal ring.
7. Move the special tool back and forth several times to make the piston seal ring fit snugly in the piston.
